Close



Dig deeper, search our News website




Search:

Type: Posts; User: Sewyboowy

Search: Search took 0.00 seconds.

  1. Replies
    2
    Views
    2,033

    Thanks for your reply. I have used PID...

    Thanks for your reply.

    I have used PID autotune in the past, however I don't think this is a PID loop problem as the temperature detected changes instantaneously by a large amount.
    I think I will...
  2. Replies
    2
    Views
    2,033

    Help with temperature detection

    Hi there,
    I am having issues with my 3d printers temperature detection. It's an Arduino and RAMPS running marlin with an e3d v6.
    The temperature readings seem stable but can suddenly jump ~20-30?....
  3. Replies
    1
    Views
    2,987

    OK, stupidly I had my rod lengths set wrong, I...

    OK, stupidly I had my rod lengths set wrong, I have altered it to the correct value and now it almost works, but each cm I tell the hotend to move, the hotend moves just over a cm, so do you think I...
  4. Replies
    1
    Views
    2,987

    Help with a delta 3d printer

    Hi,

    I just finished the build of a kossel xl 3d printer and i have done the paper test and adjusted the bed so that its level and calibrated to the center of the bed, so that the point 0,0,0 is a...
Results 1 to 4 of 4