When it is set to random you see a gap on every layer where it start/stop the external perimeter.
I am quite certain it is in the slicer program. I used Cura in the beginning because with the...
Type: Posts; User: sundewzer
When it is set to random you see a gap on every layer where it start/stop the external perimeter.
I am quite certain it is in the slicer program. I used Cura in the beginning because with the...
Thanks for the suggestion I tried them all and again no success. I check the extruder length and it was spot on. I tried under and over on the extrusion multiplier. When I went over it got better at...
Here is the better picture I promised. I tried all the tip and tricks that were suggested but I still can't get rid of that gap. Using a hollow cylinder I found out there there is the inverse on the...
Slic3r does have the ability to random the starting points but then the entire outside perimeter looks like someone drilled a bunch of small holes in it. I think it has to do with the start and stop...
Thanks for the idea. I did some research on infill overlap and I guess the newest experiment version of slic3r has an infill overlap option but the current stable version doesn't. I found someone...
I truly appreciate your feed back and help with this issue but a 5mm wall isn't always an option. I will definitely give it a shot tonight to see if it resolves any issues.
Yes it is that line, that evil little line. It is about 1mm wide and deep. I usually only run 2 vertical perimeter I haven't tried more but I have ran full solids that have the same issue. I haven't...
Not sure why the attached pictures didn't come through. Hopefully these URLS will do the trick.
...
It is sort of hard to see with the black but for the life of me I can't get my printer to make a cylinder with no void when it stops on the perimeter. I have a Da Vinci 1.0 and I am using Repetier...