Search:

Nice work Dustin :). Which fan did you pick to cool your print?

Chachin..

Today I finally got a chance to print this thin-walled cylinder again on blue painter's tape and with the heated bed off. I am happy to report that this indeed solved the warping problem! See...

For what it's worth, I had the same frustrating experience of carved out filament in my Greg accessible extruder for the first few months of printing. Then I changed to a different brand of filament...

Thanks for the feedback guys. It sounds like I should follow through with it then, especially since all my printing right now is done in PLA.

Is there a particular (quality) fan you guys would...

Thank you for the explanation Printbus. Yes, I am printing on a heated glass bed coated with Garnier Fructis hairspray. I do have some blue painters tape on hand. I've never printed on tape before,...

Greetings,

Are many/any of you guys using a fan to cool the filament immediately exiting the extruder of your Prusa i3 or i3v? If so, what have your prints gained from this? Is a fan only/mostly...

Greetings,

This is the second time I run into a cylindrical part (with a relatively thin wall thickness) that ends up being deformed in the layers closest to the bed. Reference attached photos. ...

Survey completed. Good luck!

Chachin..

Thanks 3DP. I went for it... downloaded version 1.2.9, set it up and started printing with it yesterday. Surprisingly, it was a lot easier to setup than I expected.

Chachin..

Hi Flonko,

I'm new to Prusa/3D printing as well and had a similar problem with my nozzle starting out slightly higher than I had positioned it with the homing sequence. My solution so far has...