Close



Dig deeper, search our News website




Search:

Type: Posts; User: VidJunky

Search: Search took 0.00 seconds; generated 51 minute(s) ago.

  1. Replies
    2
    Views
    14,737

    So I was getting these marks and I felt like I...

    So I was getting these marks and I felt like I was also having issues with my prints due to the feed rate of my filament. Like you I was getting scaring on the sides of my filament that I would...
  2. Replies
    4
    Views
    21,775

    My Prusa MK 3 is direct drive vs my Creality...

    My Prusa MK 3 is direct drive vs my Creality printer which has a long tube that guides the filament to the extruder. A quick Google image search will show you the differences between the two.

    You...
  3. I'm using the same brand printer and I've never...

    I'm using the same brand printer and I've never tried slowing down the first layer. I see where that would help but for me, I usually clean the plate really well to get good adhesion, and then bump...
  4. Replies
    0
    Views
    2,474

    Learn Fusion 360 in 30 Days/Videos

    Pretty sure this would qualify as a tip. A friend of mine was struggling with a project and happened upon this series and then turned me on to it. It just so happened that I was looking for a...
  5. Replies
    2
    Views
    12,845

    I'm on day 10 or 11 and this is pretty straight...

    I'm on day 10 or 11 and this is pretty straight forward and starts off simple. It's better if you have dual monitors and can run the video on one while doing the thing on the other.

    Not sure if...
  6. Replies
    4
    Views
    8,550

    That is super clean. Nice work. I'm lost when it...

    That is super clean. Nice work. I'm lost when it comes to modeling.
  7. Replies
    2
    Views
    18,941

    You could start the print at an angle and only...

    You could start the print at an angle and only print some of it vs fully committing and trying to print it all. I do small test prints a lot to cut down on wasted time later if something fails. Try...
  8. Replies
    2
    Views
    18,941

    I've had a similar experience where my print may...

    I've had a similar experience where my print may have succeeded if only the slicer had made longer straight lines instead of jumping around. I searched this question and all I found was there was no...
  9. Replies
    17
    Views
    44,754

    @patriciaf334, when you ask a question like this...

    @patriciaf334, when you ask a question like this you're supposed to tell us your pick too, but on that note, I was into COD forever. Played Black Ops 4 League as recently as last weekend. DMZ in MW2...
  10. Replies
    0
    Views
    7,339

    New to the forum

    Hello everyone,
    I may be posting this in the wrong place but I didn't find a new to the forum or welcome thread and since this would mainly be off topic I figured I would post here. If I'm wrong...
  11. Replies
    1
    Views
    14,257

    Hey how's it going? I've suffered the issue of...

    Hey how's it going? I've suffered the issue of the broken triangles not just in cylinders but in other "hollow" prints.

    What infill percentage are you trying to achieve? For me the lower the...
Results 1 to 11 of 11