Close



Dig deeper, search our News website




Search:

Type: Posts; User: dlybbert

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    4,911

    I replaced the foil tape at the corners of the...

    I replaced the foil tape at the corners of the plate. Scrubbed the plate and releveled it. That seems to have done the trick.
  2. Replies
    4
    Views
    4,911

    I have been using the "auto level" option. I am...

    I have been using the "auto level" option. I am using purple gluestick for adhesion (suggested by fusion). I will do a manual leveling and report.

    Thanks for the feedback.
  3. Replies
    4
    Views
    4,911

    ABS Layer Quality and Adhesion

    Hey,I have a Fusion3 410.

    It has worked perfectly for a few hundred hours of printing...but all of the sudden:

    The filament doesn't seem to stick to the glass during the print (first layer)....
  4. Replies
    15
    Views
    8,796

    I find that sharp or sharper corners are normally...

    I find that sharp or sharper corners are normally where the cracks propagate from. There is a good reason for this called stress raisers if you want to research it. If you dial up your heat or dial...
  5. Replies
    15
    Views
    8,796

    It is difficult, but if you reduce your sharp...

    It is difficult, but if you reduce your sharp corners as well as increase the amount of heat into your filiament it can be fixed.
Results 1 to 5 of 5