I got it to work! Main issue I believe was my hotend was flush against the heatsink and that wasn't allowing it to heat properly. I also had to run negative to pin 3 on my MK2B bed intead of just...
Type: Posts; User: bronks
I got it to work! Main issue I believe was my hotend was flush against the heatsink and that wasn't allowing it to heat properly. I also had to run negative to pin 3 on my MK2B bed intead of just...
Printer is in my garage and its 72+ F so i don't think thats the issue.
Not sure about the 4.7k ohm. I purchased the Arduino Board and Ramps 1.4 as a completed set. Got it here: ...
I would like to check the thermistors but not sure how, I assume I would check resistance but what is the value I should get to know they are working? The hotend thermistor is the standard one from...
So close to getting my first printer going. I have a Rework I3 with Ramps 1.4, E3Dv6 hotend, and MK2B heatbed. In Pronterface I try to heat the hot end up and it won't go above 140C but when I check...