Close



Dig deeper, search our News website




Search:

Type: Posts; User: JackOfAllTraces

Search: Search took 0.00 seconds.

  1. Zonestar P802QR2: How to ID stepper driver?

    Hi all,

    Is there a way to identify the stepper driver board(s) without removing the heatsink? I got a used zonestar with a new in bag controller board and am going to attempt uploading Marlin to...
  2. Enable "Save to EEPROM" without original firmware? i3 Clone (Max Micron)

    Hi folks,I have a new-to-me Max Micron i3 clone, using what one of the members here told me is a Hictop controller (the only label is "Base V1.3"). I replaced my threaded rods on the Z axis with...
  3. Yes, the plastic ones are plastic. The...

    Yes, the plastic ones are plastic. The differences seem to be that plastic are all self-lubricating, have no moving parts, and can't wear on the rods. They are practically silent and their...
  4. Bearings or bushings? (Replacing linear bearings on rods)

    Hi all,

    So far you folks seem to be the best repository of information I've found, so I'm back with another question. I actually DID search the forums here, but nothing popped up specific to my...
  5. Thanks! I will have to look around and try to...

    Thanks! I will have to look around and try to find any sort of documentation for the LCD controller.

    Your help is very much appreciated!
  6. Thank you! Also, my apologies for the...

    Thank you!

    Also, my apologies for the duplicate thread - I was inexperienced with the forum software. Mea culpa.
  7. Help ID board: Max Micron (Prusa Mendel I3 clone)

    Hi everyone,I just picked up a used Max Micron printer (Prusa Mendel i3 clone) that works well, but the Z offset is off, and documentation is sparse to say the least. I've been able to connect using...
  8. Help ID board: Max Micron (Prusa Mendel I3 clone)

    Hi all,I'm relatively good with 3d printers - my sons and I built a Printrbot Simple Metal back when they were in business, and I was easily able to access the board through the older version of Cura...
Results 1 to 8 of 8