Close



Dig deeper, search our News website




Search:

Type: Posts; User: dlybbert

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    692

    I replaced the foil tape at the corners of the...

    I replaced the foil tape at the corners of the plate. Scrubbed the plate and releveled it. That seems to have done the trick.
  2. Replies
    4
    Views
    692

    I have been using the "auto level" option. I am...

    I have been using the "auto level" option. I am using purple gluestick for adhesion (suggested by fusion). I will do a manual leveling and report.

    Thanks for the feedback.
  3. Replies
    4
    Views
    692

    ABS Layer Quality and Adhesion

    Hey,I have a Fusion3 410.

    It has worked perfectly for a few hundred hours of printing...but all of the sudden:

    The filament doesn't seem to stick to the glass during the print (first layer)....
  4. Replies
    15
    Views
    1,318

    I find that sharp or sharper corners are normally...

    I find that sharp or sharper corners are normally where the cracks propagate from. There is a good reason for this called stress raisers if you want to research it. If you dial up your heat or dial...
  5. Replies
    15
    Views
    1,318

    It is difficult, but if you reduce your sharp...

    It is difficult, but if you reduce your sharp corners as well as increase the amount of heat into your filiament it can be fixed.
  6. Thread: Test post

    by dlybbert
    Replies
    8
    Views
    1,686

    Mine too

    Mine too! Having problems with you must have 3 posts in order to post links... when I'm not posting a link...
Results 1 to 6 of 6