Close



Dig deeper, search our News website




Search:

Type: Posts; User: dsans1

Search: Search took 0.00 seconds.

  1. Replies
    10
    Views
    50,695

    Sticky: Thank you. It's been a long road...

    Thank you. It's been a long road...
  2. Replies
    10
    Views
    50,695

    Sticky: Finally got my machine operating properly and...

    Finally got my machine operating properly and printed this yesterday! Two Lenins and a bear.

    8757
  3. Replies
    14
    Views
    62,021

    Sticky: Dominik is working on the problem. Looks like an...

    Dominik is working on the problem. Looks like an update to Windows broke the installer and I'm just the lucky one to have run into it first.
  4. Replies
    14
    Views
    62,021

    Sticky: Then it is something else, because I tried it on...

    Then it is something else, because I tried it on a Windows 8 machine and ran into the same error. I'll just have to wait for them to respond.
  5. Replies
    14
    Views
    62,021

    Sticky: Yes, already submitted. The website isn't very...

    Yes, already submitted. The website isn't very clear, but maybe the software is only running on Windows 7? Unfortunate considering that software is six years old and Windows 10 has been available...
  6. Replies
    14
    Views
    62,021

    Sticky: Yes 64bit Windows 10 on an Intel i3 dual core....

    Yes 64bit Windows 10 on an Intel i3 dual core. 6GB of RAM, 1TB hard drive. Brand new machine. Connected to the internet via WiFi.

    Error reads, "The Sintratec Central Setup Wizard ended. Sintratec...
  7. Replies
    14
    Views
    62,021

    Sticky: I can't seem to get the software to install. I...

    I can't seem to get the software to install. I keep getting an error and the install quits without completing. Any suggestions?
  8. Sticky: Hi Hugues, Thank you for the reply. Joscha...

    Hi Hugues,

    Thank you for the reply. Joscha has addressed my questions as well this morning, I think I can continue with final preparations and get printing!
  9. Sticky: Turns out the instructions that were emailed to...

    Turns out the instructions that were emailed to me, were not complete and now I have found the "Commissioning" Instructions. This answers 4, 5, and 6. Sorry Sintratec for bombing you with emails...
  10. Sticky: Looks like the Sintratec Portal website also has...

    Looks like the Sintratec Portal website also has additional instructions that I did not receive in the emailed instructions I have been using. Time to go through them and see if it answers questions...
  11. Sticky: Okay I found the link to the software in the...

    Okay I found the link to the software in the Sintratec Portal website. I registered so long ago I completely forgot about being given access to that.
  12. Sticky: First, what do I do with the convex lens? I’m...

    First, what do I do with the convex lens? I’m assuming it mounts in the holder that was part of the “Hat” assembly, but there are no instructions as to when to install this lens. Before calibration?...
Results 1 to 12 of 12