Close



Dig deeper, search our News website




Search:

Type: Posts; User: Stevolution2019

Search: Search took 0.00 seconds.

  1. Replies
    1
    Views
    3,544

    Wiring for filament detector

    Hello all

    I just cannot find the wiring diagram (that I can trust) for the filament detection connection.

    I believe it plugs into X Min. Its a 4 pin socket, but does anyone know the...
  2. Replies
    0
    Views
    2,572

    SO frustrated with this thing

    Hey all
    My Flashforge creator Pro has been bulletproof for a couple of years now.

    Then it started to fail. Prints not sticking, clogged nozzles etc.

    Are they discontinuing this printer? ...
  3. Replies
    6
    Views
    6,209

    It was a combination. The roller wheel is worn...

    It was a combination. The roller wheel is worn (has a groove around it). But also the actu
    al extruder mechanism was not keeping up the pressure between the wheel and the geared cog - so it was...
  4. Replies
    6
    Views
    6,209

    Found spares

    OK.
    After a *#*$ load of searching...

    I have sourced the correct drive gear for the stock extruder (Pic attached). Fits the stock extruder drive perfectly.

    But, also sourced the entire plastic...
  5. Replies
    1
    Views
    4,027

    Nozzle jammed this morning. 20 mins with a...

    Nozzle jammed this morning. 20 mins with a blowtorch and just cannot get it unblocked. This was a new nozzle+PTFE tube 1 week ago.
    I have come to the conclusion that the Creator Pro is basically...
  6. Replies
    1
    Views
    4,027

    Prints getting worse - PETG

    Hi

    I am printing a whole load of parts in PETG.
    All started well, then the right hand extruder started playing up and now doesn't work...
    OK, over to the very little used left hand extruder...
  7. Replies
    6
    Views
    6,209

    I have to be honest, this damn machine is...

    I have to be honest, this damn machine is starting to get on my nerves!
    It has started 'clicking' and after investigation, the left hand feed roller was worn.
    So I swapped it with the right hand...
  8. Replies
    6
    Views
    6,209

    Replacement drive gear

    Hello all

    My lovely Flashforge Creator has started to be a problem child....

    Right hand heater element, or thermistor is playing up. Can't find a single heater block + Thermistor anywhere in...
Results 1 to 8 of 8