Close



Dig deeper, search our News website




Search:

Type: Posts; User: grue

Search: Search took 0.00 seconds; generated 52 minute(s) ago.

  1. Replies
    7
    Views
    6,167

    ok wow. so looks like i fixed some of this. 1....

    ok wow. so looks like i fixed some of this.

    1. i put the old bowed-in-the-middle glass plate back on - instead of using the mirror which i know to be flatter
    2. i re-leveled the glass plate and...
  2. Replies
    7
    Views
    6,167

    well, that didn't do it. cura doesn't have an...

    well, that didn't do it. cura doesn't have an adjustment for the offset, i couldn't find how to do it in the gcode, so i re-leveled the bed with a little bit bigger gap, a thicker piece of paper. ...
  3. Replies
    7
    Views
    6,167

    i'm using cura 3.1. i checked in my printer menu...

    i'm using cura 3.1. i checked in my printer menu and there is an option under Prepare>Move>.01 or .1 or 10mm> z-axis. while it looks like that may add offset to the nozzle, seems like doing it in...
  4. Replies
    7
    Views
    6,167

    since i'm such noob i'll ask --> z gap adjusting...

    since i'm such noob i'll ask --> z gap adjusting up via the gcode, is more or less equivalent to manually lowering my mirror with the thumb screws... ie) re-leveling my bed? just that i'm doing it...
  5. Replies
    7
    Views
    6,167

    nice thanks. i'll give that a try!

    nice thanks. i'll give that a try!
  6. Replies
    7
    Views
    6,167

    "shark gills" printing ugh! creality cr-10s

    hello. i was all excited to try the new mirror plate, it leveled pretty darn well as far as i can tell, using the paper method. so i started printing and things got worse and worse, turns out i had...
  7. Thread: Home depot mirror

    by grue
    Replies
    1
    Views
    2,800

    Home depot mirror

    After printing 4 model with my new printer the 5th one started failing and i am pretty sure it is because i cant level my bed properly.

    I went to home depot and got a 6 pack of glacier bay 12x12in...
  8. Replies
    4
    Views
    7,954

    update. indeed someone else has had this issue :)...

    update. indeed someone else has had this issue :) i saw that retraction seemed to be the issue. in cura i was able to disable combing mode, i set it to off. then i made sure retraction was enabled....
  9. Replies
    4
    Views
    7,954

    hm. in cura 3.1 i'm not seeing this out of place...

    hm. in cura 3.1 i'm not seeing this out of place lines on the bottom layer or the top, these prints are in progress, but the support failed so having to restart the print. they seem to correspond...
  10. Replies
    4
    Views
    7,954

    thank you fred! i was able to track down what...

    thank you fred! i was able to track down what looks like the setting you mentioned in cura 3.1. tricky of them to hide it and post the settings user manual under version 2.0 on their website ha!
    ...
  11. Replies
    4
    Views
    7,954

    printed patterns of flat surfaces

    hello. new to 3d printing. i have a creality cr-10s. i noticed when printing some flat surfaces like a rectangle or square, the printer prints concentric rows from the outside in, creating an...
Results 1 to 11 of 11