Close



Dig deeper, search our News website




Search:

Type: Posts; User: cripto101

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    1,896

    Bridging issue

    I have been looking online trying to find something that talks about this issue. My printer is doing a benchy and when it starts to do the roof it is starting in the center of the roof. There is no...
  2. Replies
    4
    Views
    5,076

    Did you add anything to it? With the glass bed...

    Did you add anything to it? With the glass bed you might need to make adjustments to your offsets. and adjust your z axis stops. This might help with that a little.
  3. Replies
    10
    Views
    7,255

    Haza!!! It lives. The printer is working really...

    Haza!!! It lives. The printer is working really well now. Thanks!
  4. Replies
    10
    Views
    7,255

    Thank you so much Tommy Dee. I will do that. ...

    Thank you so much Tommy Dee. I will do that. Once I get it in I will let you know if that was the issue.
  5. Replies
    10
    Views
    7,255

    So not sure which one I should get...

    So not sure which one I should get...
  6. Replies
    10
    Views
    7,255

    You know what it could be that the original was...

    You know what it could be that the original was 24 volt and i put in a 12 volt. That sounds like it could be the problem. Will I need to send it back and get a 24 volt?
  7. Replies
    10
    Views
    7,255

    Thank you for the response TommyDee. I did check...

    Thank you for the response TommyDee. I did check it both with the bed heated to temp and the hot end heating up and with just the hot end heating up. It maintained a stable voltage. It is...
  8. Replies
    10
    Views
    7,255

    So after some fiddeling I have been able to get...

    So after some fiddeling I have been able to get the heat bed up to temp but the hot end will only reach 145 degrees and than the system goes in to the E1 error. I have checked all the connections...
  9. Replies
    10
    Views
    7,255

    heating issue

    I did a search but could not find much to help me on this. I had a power supply burn out due to a faulty fan. I replaced it with a mean well nes 350 12. After i replaced the power supply the bed...
Results 1 to 9 of 9