Close



Dig deeper, search our News website




Search:

Type: Posts; User: PrintPunk

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    28,845

    +1 for using M3D FIO...

    +1 for using M3D FIO w/ a Pi. Some good info / step-by-step for using Octopi, Micro and M3D FIO here.
  2. Replies
    10
    Views
    49,262

    Few people have created diy heated beds for the...

    Few people have created diy heated beds for the M3D Micro using usb mug warmers. If you have access to the M3D support forum there are some recent discussions going on about diy heated bed mods/hacks.
  3. Replies
    1
    Views
    20,021

    Seems to be a bug in the latest version of the...

    Seems to be a bug in the latest version of the their software. If you are using v1.4.0.9 roll back to a previous version. If you haven't checked out the user created software alternative, google...
  4. Thread: M3D Printer

    by PrintPunk
    Replies
    11
    Views
    47,070

    +1 for the alum foil mod. Great tip.

    +1 for the alum foil mod. Great tip.
  5. Replies
    17
    Views
    46,674

    - Getting good (quality, consistent) prints with...

    - Getting good (quality, consistent) prints with ABS on M3D Micro is very difficult to achieve. The lack of a heated bed makes printing ABS problematic.
    - Use the external filament feed method...
  6. Replies
    17
    Views
    46,674

    Printing with PLA or ABS? Maybe try cranking the...

    Printing with PLA or ABS?
    Maybe try cranking the heat down a bit see if that helps with the blue tape pulling up.
  7. Replies
    124
    Views
    133,867

    Worst support ever = WanhaoUSA

    Worst support ever = WanhaoUSA
  8. Replies
    9
    Views
    6,613

    I backed the Micro on kickstarter and have used...

    I backed the Micro on kickstarter and have used it for 10 months or so. Fun little printer to play around with and learn on but I wouldn't recommend it for two reasons: 1) closed software 2) VERY...
  9. Replies
    17
    Views
    46,674

    I've always had trouble with the M3D Pearl White...

    I've always had trouble with the M3D Pearl White PLA and never was able to get a 'good' print with it. Others in their support forum report the same/sim issues.
  10. M3D has some info in their knowledge base...

    M3D has some info in their knowledge base that may be helpful to you.
Results 1 to 10 of 10