Close



Dig deeper, search our News website




Search:

Type: Posts; User: anvoice

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    2,071

    To be honest I didn't realize that there are...

    To be honest I didn't realize that there are multiple lifting maneuvers until now. Did find the need for both "lift speed" and "retract speed" strange though. I'm not sure there's a way to disable...
  2. Replies
    9
    Views
    2,071

    Bottom layer count: 3 Exposure: 3s Bottom...

    Bottom layer count: 3

    Exposure: 3s

    Bottom layer exposure: 60s

    Waiting mode during printing: Light off delay

    Light-off delay: 0
  3. Replies
    9
    Views
    2,071

    So I thought. Well, I recalibrated the plate...

    So I thought.

    Well, I recalibrated the plate and printed, to the same effect. Then I switched from 25 microns to 50 and lo and behold, the calibration seems to print fine, elephant's foot aside.
    ...
  4. Replies
    9
    Views
    2,071

    Thanks for sharing. My FEP comes from the...

    Thanks for sharing. My FEP comes from the manufacturer of the printer, and the build plate is sandblasted so it should mostly scatter the UV light. Not sure if that actually helps or not. Strange...
  5. Replies
    9
    Views
    2,071

    I also tried running some calibration prints,...

    I also tried running some calibration prints, which failed. The AmeraLabs Town mostly partially lost adhesion to the print bed and was hanging off. I bumped up the bottom layer cure times and tried...
  6. Replies
    4
    Views
    4,774

    Yes, it appeared. Thank you!

    Yes, it appeared. Thank you!
  7. Replies
    4
    Views
    4,774

    Post gone to moderation a week ago

    Hi, not sure if this is the place to post this, but my post in general discussion has gone to moderation I believe about a week ago and is still invisible. Is this normal? If it is, hopefully it's...
  8. Replies
    9
    Views
    2,071

    Layer shift and distortion in DLP print

    Hello, a bit stumped here. I have a Sparkmaker FHD machine that I am trying to get to print some parts. I've previously printed parts at 0.05mm height without much issue, with parts sliced by the...
Results 1 to 8 of 8