Search:

I just use these with threaded knurled M3 - .5 knobs from Amazon.
http://www.thingiverse.com/thing:1001405
I never trusted the binder clips in terms of running into them with the print head. Glass...

What i am saying is that the left nozzle that you tightened cold may have gone in the hot end further than it would have hot. If you have already heated it back up the point is moot and you'll have...

Here is a video for the FF printers with the glass bed mod.
https://www.youtube.com/watch?v=PNqkgjplGhc

I would not over think the glass bed thing. I use clamps like this. http://www.thingiverse.com/thing:715545 I modeled mine myself so I can accommodate the glass thickness that I am using. I use...

I use a similar setup on my ff machines but read the fine print on the glass. It states the size may vary by 1-3cm. That is way too much for those clips to work. Look for a local glass ahop and have...

Glass bed, glue stick if prints are not sticking, freezer if the prints don't pop right off after cooling.

The 1/8 thick glass will chip and crack easier. Not the end of the world but if you are counting on the bottom to be smooth and one chips or cracks.... well.... the 3/16 is more durable and the heat...

They ran out of stock a while back. This is why i ended up with the 1/8. They are restocked now. I did notice the same thing with their stock. I agree about the 3/16" plates being the best.

I...

10119

The product that I posted a link to does work very well and it's not flammable and doesn't stink. I printed this in two pieces this weekend. Total build time was 23 hours and some change....

I use a similar design to the ones on thingy verse. Theirs we for a thicker plate. I use 3mm glass.

I clean it off and reapply to prevent build up. The print will pull the hairspray off when it...

I use this on the glass.
http://www.garnierusa.com/products/styling/hairspray-and-hold/hair-spray/full-control-anti-humidity-non-aerosol-hair-spray.aspx
It's non-aerosol, cheap and comes right off...