Yes, that's what I ended up doing with the correct firmware this time. Thanks!
Type: Posts; User: mnmattie
Yes, that's what I ended up doing with the correct firmware this time. Thanks!
I had nothing but trouble with the Hexagon, ended up going to an E3D and haven't had jamming issues since. (just other issues)
Tried doing a firmware update to get ABL and totally screwed it up, pretty sure it's bricked......ugh
Picking up an arduino uno tomorrow to use that as a programmer and hopefully fix the printer...
Going away from my hexagon hot end and looking for a new alternative. I would like to try the Lite6 as I only print in ABS and PLA at the moment. I see Colin has them on the site for $31.50. Anyone...
Much better! :D
What's everyone doing to get a better way to crimp the ends of the X-axis belt instead of the supplied cable ties?
Matt
Currently running PLA from Microcenter, 1.75MM, white. I was perplexed that I could run one print, but couldn't run another print back to back without a jam.
I am running the heatsink cooling fan...
Ditched all the extra insulation under the bed with the exception of one piece of cardboard. Got my Z height dialed in and bed leveled. Adjusted my Estops and got it close enough to dial in the rest...
Didn't get a chance to tweak the Esteps lastnight, ended up being a late night at work.
I did, however, get a chance to throw a dial indicator on the X carriage quickly to see if my bed was...
That makes much more sense! I will definitely give that a shot tonight when I get home.
Also plan to Re-level the bed and use a drop indicator just to compare it against the X-axis and also the...
Yes I do. I was finally able to adjust my Esteps and have it save. I was able to get my Esteps alot closer to being dialed in, but still off by 1MM. Everytime I measure the filament and run out...
Thanks for the reply Chadd. I tried changing the Esteps through the lcd but coudn't get it to save. Hoping I got it down this time.
Matt
OK! scratch all of that! I wasn't thinking and tried sending info to the COM port of the printer while having repetier connected to the printer. Got it burned and enabled the EEPROM settings for...
Ok so let's back up to step #4. I've allowed arduino IDE to create the new folder needed for the "Marlin_RAMPS_EPCOS_i3v10.pds"
Step #5, Am I suppose to cut and paste all the other files into the...
Hey guys!
Been reading some very informative posts here! I currently own a 10" i3v and working on doing the correct calibration on the unit. I'm using the calibration extruder esteps guide from...