Search:

This has been bothering me too. So... solution!
Here is a link directly to my PostImage repository so everyone can see the images in FULL resolution.

https://postimg.org/gallery/1v2m10jn8/

In...

Galvos and Alignment

You have noticed that one of my previous pics had the laser drawing very close to the side of the test container. It “should” be drawing directly below, so why wasn’t it?
...

Mirror update:
Sacrificing the mirror was a success!!
Turns out I still had the clear layer on BOTH mirrors!! I suspected as much as the beam was not very focused in the few tests I did on the glow...

Dripper Oddity
Getting the drip system started seems to be straight forward and easily repeatable.
-(assuming all hoses properly connected) Have the Return hose and the short Purple hose (see pic...

Plastic tweezers would be AWESOME !!!
I've been poking around fiddling with peachy parts with pens, wires, small screw drivers and if I'm not careful, they get stuck on the magnets. Then i have to...

Thanks for the PostImage link and info about the check box!!

Here are a few images that I have taken so far.

Mirror Alignment fail:
The laser hits the inner corner of the mirror screwing up...

I'm playing with the drip feed system now to get a good understanding of how it works (and doesn't :-)

I'm using a 2 litre pop bottle for my salt water source and a 4 litre glass cylinder as my...

Printer and drip system are fully assembled !!!
Here are some pics!!

(OK, the forum REFUSES to upload any pics. Is there a size/resolution limit ?!? I have several I will upload once I figure...

Printer Complete !!
Well, almost. I still have to setup my container, the mesh base with handle and the drip system....but the printer itself is complete.

I had some fun with the mirrors. There...

Hi everyone!! TheJ (Jason) here in beautiful BC Canada!

Two weeks ago, I drove from BC to Manitoba and back again during my holidays. On the way back, I had the opportunity to spend almost 10...