Check out using Autodesk Meshmixer for support generation and then slice with anything with supports turned off. Meshmixer can let you do tree like supports that might work better than the kind...
Type: Posts; User: amoose136
Check out using Autodesk Meshmixer for support generation and then slice with anything with supports turned off. Meshmixer can let you do tree like supports that might work better than the kind...
Builder1, could you post some good up close images of the galvos? (multiple viewpoints, good lighting, etc) I haven't given up on magnetic damping yet but it's been difficult to replicate what was...
I contacted a Makerjuice chemist and asked what happens chemically when resin goes bad but all he said was "Typically what you will see is the viscosity slowly increase and/or the resin will become...
What kind of resin? Depending on the resin it could either be the polymer itself or simply the photo activator that went bad. If it's the activator you might just be able to find out which activator...
Try giving Craftware a shot.
Re: the wet prints, if you're using makerjuice resin, I have some and had the same problem with the finish in my first tests of it. If its oxygen causing problem as Rylan suggested and as it may well...
Photos next time would be great. I have my own (unofficial) parts now and will be building my own take shortly if some upcoming galvo tests are successful. Thus far I've spent under $50 USD in parts...