Search:

I would also like to see more technical details about the printer. Print speed, how the resin is loaded, how long can it be stored, that kind of stuff. Never looked into SLA that much. Allot of...

Kind of overdone of you ask me. First of all you need to print out of center or the glass plate will tip over if the robot has to take it on the sides. So you are not able to print large objects....

What do you mean turning it 90 degrees? No matter how the fan is orientated it will cause a draft no?

I don't have warping at the bottem layers. The problem is about curling on upper layers when...

This week I upgraded my printer with a MOSFET controller so now I can reach 90-100 degrees which is required for ABS printing. Well this new material means a new learning curve. The first problem...

And what is that? :-)

You are right, I've added it to the post, it's a velleman :-)

Here you have the link:

http://www.thingiverse.com/thing:254133

If you want to scale down the model: check the remix section, I made part D2 without the fine railings, so it's easier to print...

We all love 3D-printing because we can see ideas come to life. Therefore I made this thread so you can show off the prints you are most proud of and why. Additional info like print-time, issues you...

Hello,

I'm using a K8200 from Velleman. Aka 3Drag:

134613471348

I have modified it for better quality. Started with printing ABS last week with quite some satisfying results so far.
Btw the...

Thanks for your reply, yes it is an ATX. Just out of curiosity, why should I choose for this one? I mean by that why do I want 12v instead of 24?

I've seen allot of people (on another forum) using...

Hello, I have a 3Drag/K8200 DIY 3D-printer and I am currently busy with installing a mosfet controller to fit a additional power supply since the original supply is not good enough to get enough heat...

I made some parts to adjust the belt tension on my printer, the effect seems to get less but it's still there. Maybe the only way is lowering the print speed..

I'll figure something out to make the belt tension adjustable and I'll start experimenting with that

Hello,

I've been printing for a while now and there is 1 problem I can't seem to figure out what is causing it, I'm guessing belt tension but I think my belts are at the right tension.

I have...

Hello,
I'm also a engineering student (industrial chemical process engineer, KULeuven Belgium). I'm also experimenting with an DIY FDM printer in my free-time. I read your paper with great interest....