Search:

I do believe I have found the problem.

Ditched the firmware and replaced it with Repetier's firmware. On my second "test" print (20mm calibration cube) and it's looking good so far.

Have to get...

Nothing wrong with the card. It's a Lexar 4GB card that formats/reads/writes perfectly fine. Was tested on 2 Windows and 2 Linux boxes.

I extended the cables and isolated the controller away from the printer. No change. Issue still persists.

I ordered a new Mega and RAMPS from Amazon. If the issue still remains after I try those...

The board is mounted where it's shown in all the documentation and assembly videos I've seen of this thing. I don't understand how things should all of a sudden be different now.

The only thing I...

SD card. Always.

Nobody? Anybody?

I purchased a used delta that's supposedly a Micromake "clone", or so the guy said.


I have had a cartesian (Tevo Tarantula) for about 6 months now and have it mastered. I am a total noob when it...