Search:

I've got a Kickstarter campaign currently underway:

https://www.kickstarter.com/projects/522476987/filament-roller


Check it out!

Hello Raph Zoontjens;

I previously promised a mechanically inline version of the filament roller that can be mounted near the extruder, separately from the spool. You can see it here:...

Topic 2: small spools
I made a mistake -- the smallest width spool that my design can accommodate is 5cm. The base itself can handle very small widths; however, I did not consider the width of the...

Topic 1: output for out-of-filament detection
Yes, it was an oversight to not initially include this signal. I revised the interface to include the following signals:
1) 5-24 V input (OR use the DC...

Topic 1: jerkiness
You are correct that most filament spools "jerk" or unroll at an uneven rate. However, though not perfect, I believe my design unrolls much more smoothly than your typical...

Hi guys, this is my first post on this board. My name is Chris and I started printing on a clone i3 back in April of this year.

I have a pretty weak direct-drive extruder and experienced lots of...