There are so many good ideas on these forums! As I read, I keep getting more inspirations...
OK, the displacer would work fine, but an even better method uses a positive displacement pump,...
Type: Posts; User: DoulosDS
There are so many good ideas on these forums! As I read, I keep getting more inspirations...
OK, the displacer would work fine, but an even better method uses a positive displacement pump,...
From another suggestion: the flag signal could also trigger dunking a displacer in the print tank to raise the resin level momentarily and ensure the previously printed slice is evenly covered with...
I lucked into a 55-gallon drum of clear UV cured resin, but I suspect it has a higher viscosity than Peachy Juice, though I may be able to thin it. (Does anybody know the viscosity of Peachy Juice...
I like the bobbing displacer idea best. A negative buoyancy mass located in a corner or at the side of the build tank could be supported by a linkage to an eccentric on a small motor shaft. The...