Yesterday i rebuilt my bed system, its much more robust & rigid now. The first print i tried went very well. im going to try and get it dialed in real nice now. Thanks for the help, i will keep up to...
Type: Posts; User: AlexD
Yesterday i rebuilt my bed system, its much more robust & rigid now. The first print i tried went very well. im going to try and get it dialed in real nice now. Thanks for the help, i will keep up to...
I havvn't had all night to try and resolve the issue but here are a few more probes after trying to adjust, its not easy with my bed design.
RECEIVED: Bed Height Topography:
RECEIVED: ...
Ok so this is the feedback from my first set of probing
RECEIVED: +0.39340 +0.05090 --0.27160 --0.61660 --1.33160
RECEIVED: +0.55590 +0.27840 --0.01410 --0.35160 --1.06660
RECEIVED: ...
Hi Roxy, thanks for the reply. I have not tried the 3 Point Probing yet, i believe that was Astek, i did not try it because i thought the Grid was superior. I will flash that firmware this evening...
Haha at the moment only just over half is useable as i am using 2 210 x 240mm Silicone heated pads, i cant seem to find an appropriate heater to use, without importing a Monster Heat Bed (18" X 18")...
Astek,
Thanks for the response, I have since realised this about the EPROM, is there any reason that the EPROM cannot be disabled? I would prefer the values to be loaded from the config as...
Hi Roxy,
I have read through a pretty decent chunk of this thread. I have implemented ABL on my printer but as others, am experiencing some problems with it. I have attempted to implement the...