I have ruled out "overheating" of the stepper motors. I designed a large rectangle that covers the entire platform and started the print. It printed it successfully in 2hrs without freezing. The...
Type: Posts; User: Txjeeptj
I have ruled out "overheating" of the stepper motors. I designed a large rectangle that covers the entire platform and started the print. It printed it successfully in 2hrs without freezing. The...
Annndd the new motherboard didn't do anything.... Problem still exists.
Ruled out the print file, as they printed the same x3g that I am trying to print (except they printed it successfully).
...
Contacted FlashForge, they are sending me a new motherboard. Will update w/ results.
I updated the firmware and also ReplicatorG sailfish. Tried to print again, this time it got to the second layer (an improvement..) and then froze - heaters turned off, printer reset/played the tune...
I always run the code via SD Card, I tried running it through USB/Computer to see if the SD Card slot was screwed up - but the USB/Computer froze also. The computer did not go to sleep or anything,...
I just tried to print something from Thingiverse and it froze just after laying the first layer of skirt down. It seems to be freezing sooner and sooner each time I try a print.
This time it...
I have a FlashForge Creator, which is the same thing as the original MakerBot Replicator (Wooden Box).
I have been printin via SD card for the past few months with no problems at all. All of a...