3 Attachment(s)
CR-10 Possible underextrusion?
Hi everyone,
I recently bought a CR-10, and I decided to print a Benchy at 0.05 mm layer height with 15% infill. I noticed that there are holes/gaps in the support (as shown in the picture below). I thought this could have been underextrusion, but the other areas printed flawlessly. I am also pretty sure that the top layer didn't fill in completely since I only used 2 perimeters. I used Craftware to slice this. Could anyone help me with a possible reason as to why there are gaps in the support?
Attachment 11125
Attachment 11126
Attachment 11127
Thanks,
Protolate