CTC 3D Dual Extruder and Simplify3d Software

My 3d printer prints fine using Makerbot. whenever i try to print using simplify3d, the ABS filament comes out slow and begins to clog up. Anyone using Simplify3d with a CTC3d printer? I think my FFF settings need to be tweaked but not sure what to do.

I'm using Simplify3D too. I tweaked the values by experimentation. What I suggest is you go to your process page and put here screens of all the tabs and we can discuss that.

Here are the remaining settings.

http://3dprintboard.com/attachment.p...tid=4949&stc=1http://3dprintboard.com/attachment.p...tid=4950&stc=1http://3dprintboard.com/attachment.p...tid=4951&stc=1http://3dprintboard.com/attachment.p...tid=4952&stc=1http://3dprintboard.com/attachment.p...tid=4953&stc=1

I had to delete my original post because i couldnt edit it. "The message you have entered is too short. Please lengthen your message to at least 10 characters."

http://3dprintboard.com/attachment.p...tid=4964&stc=1http://3dprintboard.com/attachment.p...tid=4965&stc=1http://3dprintboard.com/attachment.p...tid=4966&stc=1http://3dprintboard.com/attachment.p...tid=4967&stc=1http://3dprintboard.com/attachment.p...tid=4968&stc=1

Please :
1/ try to enlarge a bit
2/ I think the most important would be to display your extruder temp tab as well as be temp tab and finally the tab with all the speeds.