3D Printer Enclosure

Hey all

These days I tried to print a gear knob for the car and after 3cm I had the wraping problem. It printed another 2-3cm well and then again.Reading on the internet I came to the conclusion that it was because it had cooled very quickly. I had a few rectangular aluminum tubes I began to make the box. I also used two Ikea tables hahaha (they have the perfect dimensions) to make it a little higher and store things below. I bought a 5m led strip to light it. The isolation was given to me by a friend.
This is how it looks

Attachment 13802

Attachment 13803

Attachment 13804