I am new to 3D printing and just sat up my new Ender. The problem that i am having is the prints keep going off to the right of the bed. The X Y Z are flashing and it says 0 next to them. What am i doing wrong?
Printable View
I am new to 3D printing and just sat up my new Ender. The problem that i am having is the prints keep going off to the right of the bed. The X Y Z are flashing and it says 0 next to them. What am i doing wrong?
Also, just attempted to do another print and it is suppose to be printing at 50.2 X 37.5 X 42.0 mm and it is printing extremely wide and thin and going to 123 X, 139 Y. It's making a weird noise and I'm not sure what is going wrong.
Is it the very first print? It sounds like something isn't set up correctly in the firmware, or possibly you've got a cable connected wrongly (less likely). where does the auto-homing go to?