Filament not coming out when printing

Hello!
I have a Flash Forge Adventurer 3 Lite printer. It appears that there is no filament jam because when I load it, the filament comes out properly. The problem is when I try to print. The printer parts move as expected but the filament won´t come out from the nozzle. I would appreciate any help. Thanks a lot in advance.

What slicer are you printing from; FlashPrint5?

Does the feeder click when attempting to print (trying to push filament that won't move)?

Many things could cause that problem, from a loose wire connection, erroneous slicer setting, bad stl file, etc.

Things you can try:

Unplug the printer for a minute and plug it back in; reset the electronics.

Check your nozzle temp when printing and make sure it's not shutting off.

Try printing a known good .stl file to make sure it's not just a bad file you're trying to print.

Good luck, hope you get it working.

Quote:

---

Originally Posted by nozzle

what slicer are you printing from; flashprint5?

Does the feeder click when attempting to print (trying to push filament that won't move)?

Many things could cause that problem, from a loose wire connection, erroneous slicer setting, bad stl file, etc.

Things you can try:

Unplug the printer for a minute and plug it back in; reset the electronics.

Check your nozzle temp when printing and make sure it's not shutting off.

Try printing a known good .stl file to make sure it's not just a bad file you're trying to print.

Good luck, hope you get it working.

---

thank you very much. I´m using flashprint. I´ll try your tips.