Does the software for the USB version exists ?

Hi all,

I received an USB version of the kit last month, so it seems to be what was supposed to be the "final version", but I still have not finished to build it, and I was wondering if the software to pilot it exists somewhere ?
I have read most of the thread speaking about software, but I am not sure if what can be found on the github is compatible with this version of the hardware...

Regards,
Seb

Hey Redox,


Here is the web page that links to software dl, instructions, and the peachy forum:

http://www.peachyprinter.com/#!get-started/en0zq

As long as you haven't upgraded the firmware on the board, that link should just work.

Good luck with the build!