Printable View
Hi I have a z605 printer, I got a ramps board for it someone on here recommended it, I have repetier host but I cant get the repetier to move the axis of the printer, im not sure if I have installed th software correctly, any ideas? Im in perth. the pc picks it up when I got into the ports I gt the baud rate etc correct I think.
cheers
Mike
Send M119 to the printer to report the end stop status. If you get nothing back, you've not loaded the firmware correctly. If it tells you the end stops are triggered, either you haven't connected the end stops yet, they're wired incorrectly or the firmware is not configured correctly for them. If the firmware thinks your endstops have been triggered the motors won't move toward the end stop position. Same for max end stops, meaning your motors may not move at all.
Post the results of M119 here and the contents of your configuration.h file and we should be able to help you further.