First Print Pegasus 12 X axis issue

After a few months of required attn to some work around my house I finally got around to finishing my first build.

Printed this cube with Hatchbox PLA at 200 ext and 70 bed. .2 layer height. Using S3d and a profile I got from this forum.

As you can see the left side of the X axis is all over the place, the bottom is facing you and did not fill on the left side. My initial thought was loose belt but I could barely get that X belt on because I cut it too short.

Ideas?

https://content.screencast.com/users...01-20_1003.png

Have you properly adjusted all your eccentric spacers on your rollers and adjusted your rollers so they glide along the rails smoothly without bouncing around?

Thanks hopster, I had one wheel that was not contacting the rail as well as the other 3 and there was a tiny bit of slop in the carriage. Tightened those up and am trying this again.

Best benchy I have ever made in PLA and I don't even have a part cooling fan.

https://content.screencast.com/users...01-21_0948.png