Looking for help with printing issue Anycubic Chiron

When I first got this printer I only had issues with small details. Have since found out those issues were caused by z wobble and fixed that issue but now I am still having issues getting a benchy to come out really good. for the most part I am having issues with the bow of the ship as it looks like its just melted off, but I have tried reducing printing temp down as far as 190 and the print got more stringy than before and still had the same issue. I also attached a photo of the front window of the benchy as that overhang is also kinda bad but that might just be caused by the 90 degree overhang.

Benchy 1 is showing the overhang if anyone has some tips to try and clean that up a bit

Benchy 2 is the real issue I am having with the bow of the ship.

Settings I used on that print were:
200 degree print temp
60 degree bed temp
0.08mm layer height
60mm/s print speed

using Cura for splicing

If you need anymore info please let me know as I dont know what other info is important