Sx2 Simple SLA DLP Resin 3D Printer

Thingiverse user Bazzz, of the Netherlands, offers makers and hackers a DLP 3D printer that may be worth looking into building. Using an basic projector with 2000 lumens or more, Bazzz offers a top-down design for simple design of his Sx2 Simple SLA DLP Resin 3D Printer, which may offset expenses incurred by resin. He recommends using MakerJuice subG+ Resin for rapid curing times of each layer, and states that you can expect great quality without the need for expensive lenses or mirrors. Find out more details on this potentially cost-saving DLP design, check out the full article: http://3dprint.com/46468/sx2-sla-dlp-resin-3d-printer/


Below is a photo of Bazzz's design:
http://3dprint.com/wp-content/uploads/2015/02/five.jpg