3D Print a Wind-powered USB Charger
Anthony Dorsa, a sophomore mechanical engineering student at Binghamton University, designed a 3D printed, wind-powered USB charger after seeing the Thingiverse Catch The Wind challenge. After experimenting with a few turbine designs, Dorsa settled on the proven Savonius cup for its efficiency in smaller sizes. He also plans to incorporate a voltage regulator into the design at some point, and he's working on hand-cranked and solar versions of the charger. You can read the whole story here: http://3dprint.com/85171/wind-powered-usb-charger/
Below is a look at the 3D printed wind-powered USB charger:
http://3dprint.com/wp-content/upload..._featured1.jpg