Over Extruding with an AnyCubic Mega S and Cura 4.4

Hello forum.

I am new to 3D printing and have had reasonable success with printing small miniatures (something with not much surface area).

However, I have been trying to print something with a bit more width and I have an issue (that was also present with my earlier prints, but did not cause so much of an issue as they has a small surface area).
The issue is that I seem to be extruding when the print-head is moving to its next position. I have spent a lot of time ensuring that the print bed is level and clean. I have adjusted the 'Retraction' configuration within Cura but to no avail.

The printer is an AnyCubic Mega S with the supplied 1.75mm filament.

Any help or pointers will be gratefully received...

Harold Clements