-
1 Attachment(s)
Sloopy Prints.
Howdy all, I have a ANYCUBIC Mega X. Prints weren't sticking so I got a new glass bed. Nozzle was underextruding (probably) so I replaced the nozzle. I am getting really sloppy prints, albeit better then they were, but can't i do better with slicer settings (Cura)? I am using PLA, nozzle width=0.4mm. I have varied temperature, layer height, speed, but I don't seem to be getting nice prints. I have enclosed a picture. the part is about 32 mm.
-
Have you run the calibration in Cura around the flow rate? Possibly might be too much filament coming out at once, or the print is too slow?
-
Thank you. I am not familiar with the calibration function in Cura. i will take a look for it.