Printable View
Okay I guess I am late to this party and I just got a One UP and assembled it - however when I print the filament 'squirts' out the side of the extruder *even though I feed it completely into the hotend* and the print stops.
It does not seem like a slicer / repetier speed thing as it has happed at 1, and .9 speeds.......
thanks in advance:confused:
Can you supply some pictures?
if you can see (a bit hard because it is black filament) but by the roller on the side of the extruder you can see the filament coming out there
What size of nozzle are you using? Little better picture that is closer would help. Swing more around the back too.
it is a .4 nozzle - I will take more photos tomorrow sorry about that I took it apart to 'unjam' it as soon as it happens again I will take more photos
Don't necessarily need a picture of it jammed, just a good look at the back. Want to make sure there isn't too big of a gap between the feeder and whatever is between it and the hot end.
I will try to get an infocus pic (my camera battery just died)
it is about 3/4" from the extruder to the hotend hopefully you can see
Wow. How do they expect you too not have that problem. I downloaded the manual and it looks right.
http://i130.photobucket.com/albums/p...psxd85iwup.jpg
One last thing, what is your filament size in your slicer set to?
it is set to 1.75 and the multiplier is set to 0.98
so what if I drilled a opening into the top of the hotend - and inserted a piece of thought on top say 1/2" high will that stop it ya think?
I bet it would!!
That worked like a champ thank you very much!!!!!
Glad to hear that you got it going.
Can you supply some pictures?