What is a good ABS:Acetone ratio for a print bed slurry?
I started off with a 1:4 (v/v) mix that as a bit thin.
OME
Printable View
What is a good ABS:Acetone ratio for a print bed slurry?
I started off with a 1:4 (v/v) mix that as a bit thin.
OME
....try to get a viscosity similar to a very liquid oil. the slurry works better when its more liquid...
we print a lot with uhu stick (similar to pritt stick) instead of acetone-abs-slurry, easier to handle and not hazardous.
ABS sauce/juice?
I tend to avoid slurry, I need to have liquid like so I can spread much easier on a 12" bed.
And 1:4 ratio is still too much.
You can check this guy video. He has his own preference.
https://www.youtube.com/watch?v=z7avywzARzk