3D printer loops

Hey guys,
wanted to ask if you guys knew what this is and how to get it rid off?

I heard this was due a to low temp or to high?

https://www.dropbox.com/s/d4ril7ohh5...2021.03.30.jpg

Hoping someone can help me on this one ^^

Thanks guys !

Nobody seems to know the cause of this ? :?

Luigi, not sure what you are referring to in the picture. Could you try and explain what you are asking about?

Quote:

---

Originally Posted by KDog

Luigi, not sure what you are referring to in the picture. Could you try and explain what you are asking about?

---

Well can't you see those lines at the top? Some are not placed on the item correctly and has a outgoing loop.

Is this PLA? It could be water in your filament. I keep mine in an air tight container with desiccant. I live by the ocean so things get moist and salty.

Well, it shouldnt,

My room isnt that moist at all, i also use a sponge filter to avoid dust.

Can you hear it "POP" when you are printing? If there is water in it then it will make a little popping sound as it extrudes. You don't have to live in a very humid environment for this to be an issue.

I dont think so?

I have heard it might be that i run it to cold or to hot tho. (The hotend)

I thought someone mentiont this in a thread once.

Hey Luigi, I have not been 3d printing long but I have been hammering out many prints in search of the Perfect print... my suggestions on the image is as follows: - the little lumps in the print are where the 'loop' / 'layer' starts and finishes then moves up to the next leyer - the lines that i think your asking about (as you get closer to the top), is where the angle of the curve is almost too steep and there is less filament touching each other - the little stringy piece looks like it is from when the print finishes and returns 'home', the pressure in the nozzle will continue to push plastic out. I hope they help and this is not an answer from an expert, just a nooby CYA POM