1 Attachment(s)
Fan only goes to 50% in code despite setting, feel i'm missing something
I use repetier w/ the cura slicer engine for this. Looking at gcode I'm at 50% fan speed after layer 1 and then it turns off at completion. The slicer is just not going past 50% fan speed for some reasonAccording to my printer settings i see at .50mm i should be at full fan speed. This is the only fan control in entire print at 50% DC.
Code:
LAYER:1
M106 S127
G0 F9000 X109.002 Y148.375 Z0.580
And then in my filament setting I can further fine tune this based on layer time, etc (See attached image).
I just do not see any other fan speed settings that would cause this, anyone have any idea where else I can look? I also looked in printer settings but found no mention of anything cooling related.
Thanks
Dave