3D printer "Bumps" issue

Hi, i keep getting these weird "Bumps" on my prints, i didn't used to but i do now and i don't know why. I just know that its a big issues and it actually prevents the extruder from moving over them

I've tried turning the temperature of the extruder up and down, and the z axis offset up and down, but that doesn't seem to have any affect

(Im using an Anet A8 with an autobed leveling sensor, and SkyNet firmware installed)

My Cura settings (I added G29 for autobed leveling later)
Attachment 12929

Examples:
Attachment 12928 Attachment 12927