2 Attachment(s)
Awful prints after replacing gantry carriages
Hi,
I have an Ender 4 that I have converted to CoreXY with a mod from thingiverse. It looks like this:
Attachment 13713
I replaced the gantry carriages (the blue parts) on it because they were heat-damaged after the the printer was transported in my car (it sat in the sun and the car heated up). Even with the damage, my printer was making halfway decent prints, but I wanted to restore full functionality.
After replacing them though, the prints were much worse. I've never seen anything like it. Here's a pic:
Attachment 13714
I'm stumped on this one.
Just FYI, I'm using a Duet 2 controller board with this printer.
Any ideas?
Thanks