Prusa Slicer and an MP10

I’ve been 3D printing with an Anet A8 I built and a Monoprice Maker Select V2 since early 2018 so I’m not completely new to this but I’m having an issue I can’t figure out and I’m sure it has to be a simple settings issue.

I just bought a Monoprice MP10 and when I use Prusa Slicer which is what I’ve always used with my two other printers it’s trying to print about 1/16” above the bed and no matter how much I adjust the Z offset on the printer itself it does nothing.

Using Cura it works just fine, I’m just not a big fan of Cura. It’s clunky and slow even on my fairly powerful desktop, let alone with the MacBook I use for my slicing software. I’ve been through the settings between the two over and over and can’t seem to find what’s locking me out of adjusting the Z axis.

Thanks in advance for any advice.

Well I never figured out what setting/s it was but I fixed it. I deleted all of my Prusa configurations and started from scratch, so far so good.