While printing, the Ender 3 pro extruder goes off to the edge, the side of the printer and just gets stuck there.
This is demonstrated in the following video: https://tinyurl.com/y4dy5xdx
Please help!
Printable View
While printing, the Ender 3 pro extruder goes off to the edge, the side of the printer and just gets stuck there.
This is demonstrated in the following video: https://tinyurl.com/y4dy5xdx
Please help!
This could be the cables are mislabeled, this happens once in a while.
If you follow the cable from the controller to the stepper motor and from the end_stop switch to the correct location on the controller.
This is the only way to see it the are correctly labeled.
Please can we have some more details.
1 is this a new machine that has never been used before
2 Does this happen when you use Auto Home for leveling
In the beginning of some of my prints, the extruder makes a popping noise so I replaced the extruder release arm. It's still happening and I have made sure nothing is too tight or too loose and racked my brain trying to figure it out. I know e-steps are talked about, but how do I figure those out? Any suggestions would be totally appreciated!