Kudo3D Introduces 2nd Generation PSP Container

We recently launched our second-generation passive self-peeling (PSP) resin container. Our testing of the container has yielded excellent results. We have completed 52 prints in a row! We are observing higher resolution and better surface smoothness. We only used about 200g of castable resin to complete all of these prints.
http://3dprintboard.com/attachment.p...tid=5201&stc=1

Printing speeds have increased as well! At 37 microns XY and 35 microns Z, we are printing around 40% faster at 1 inch per hour. Printing at lower resolutions such as 50 microns and 100 microns XY is faster as well, but the increase is not as high as 40%. All of the prints in the picture above took between 1 to 2 hours to print. The rings took only 1 hour!

http://3dprintboard.com/attachment.p...tid=5202&stc=1http://3dprintboard.com/attachment.p...tid=5203&stc=1

A bit of confusion... Second generation resin, as stated in the post, or second generation resin container?

I was not able to find the purchase link for this revolutionary new product!

Hi fred_dot_u,

Thank you for catching that typo! It is a second generation PSP container and it is available through our website:

http://www.kudo3d.com/product/psp-resin-container/

It has replaced our original PSP container and our prices have remained the same.

Take care!

Roberta

Can a first generation container (unused) be exchanged for credit or otherwise upgraded to reduce upgrade expense?