I bought Cobees III mini printer. The printer start printing offset by X and Y about 10 mm. Where in marlin configuration file can change the value?
Printable View
I bought Cobees III mini printer. The printer start printing offset by X and Y about 10 mm. Where in marlin configuration file can change the value?
Have you configured the correct bed size into Cura ?
If the printer comes with its own slicer, perhaps try that first.
After a lot of read I found solution adding G92 X10.3 E0 and G92 Y-10.3 E0 to start g-code in Cura.