Can it be printed?

Working on creating a mount for a tablet in my dash and I am going to send it off to be 3d printed since I don't own a printer. I don't have any experience printing and wasn't sure if the clips can be printed since the clips kinda hang over and that part not supported.


http://www.picoolio.net/images/2015/...Clips4b2b9.png
http://www.picoolio.net/images/2015/...ottome4d36.png
http://www.picoolio.net/images/2015/...Front25e6a.png



http://www.picoolio.net/images/2015/11/28/left5b04f.png
http://www.picoolio.net/images/2015/...Right9e170.png
http://www.picoolio.net/images/2015/11/28/R166546.png

With support, yes. You pay for that plastic in the price. ;)

Most hobby printers probably can't print anything that large.

I'm estimating that's 10-11 inches wide at the widest?

Heck, if he's going to send it out to get printed, no problem.

Yeah its probably about 10 inches wide. I just wasn't sure with the upside down L shape for the clips would hold don't know much about 3D printing do and don'ts when modeling.

Its a bit large for a consumer (home) printer but definitely printable. And not that much more expensive either.

The Davinci (surprisingly) might handle that, it's 8" ^3, but I'd have to kick it at a 45' angle from the print bed, making the amount of support required prohibitive. Half the build space would be support!