CubePro - issue with PrintJet.

Does anyone of you had similar issue as me (see the picture), the ABS plastic melted and stuck around the nozzle.
Is it possible to remove it? how ?

Regards

http://3dprintboard.com/attachment.p...tid=5588&stc=1

if it still heats I would slowly heat it up and peel away any soft plastics..
If not heating up I would place it in the oven at 250 degrees and then peel it all away..

But I've never seen this before ..

Im worry about those cables, so that maybe put it in the boiled oil ?

?? oil ?? No not in oil .. just make sure the parts are hot around 200 degrees should be sufficient..
And all could be salvaged.. but not in oil.. just make sure the whole thing gets hot, therefore I mentioned the oven.. put it on a dish that you won't need anymore,no oil no nothing, just make it hot.... The insulation of the wires could suffer but that is an easy replace..

the Abs just needs to be soft or softer again!!