2 Attachment(s)
Workbench: Let's See Your Setup
First post here,
I'm running a Replicator 2 with a heated build plate (kept rep2 single extruder as it prints PLA and ABS without issues), aluminum arm wraps, and some other random small things. I've redesigned the active cooling fan mount so it doesn't have the top cover going over the extruder. To hold the guide tube in place I made a new lever arm that has an input to hold it in place instead. The extruder is easier to service and the motor probably sheds heat a little better. No complaints with this setup other than getting a process dialed in to prevent warping.
Here's my setup. I live in a small single bedroom apartment and this area in the back of the living room acts as my workbench and garage haha. Just a single bench with my rep2, and a toolbox with necessary tools and some spare parts. I store filament in ziploc bags below. What is your workshop/area setup?
Attachment 3815
Here's a close up of the extruder with the modified fan mount and lever arm that I referenced earlier:
Attachment 3820